Description of TUEC No. 700 Hand Model Cleaner

The handles are furnished in sections of 7/2 feet each made of 1% inch diameter
brass tubing with bronze connections. These handles are attached to the cleaning tool
and also connected together by slip connections with bronze clamps which eliminates
the possibility of their coming apart while the cleaner is being used.

_TUEC 1’ inch inside diameter, specially constructed, rubber covered, rubber lined,
reinforced hose is furnished.

The inlet for connecting the cleaner to the piping is made of bronze with smooth
taper to fit tapered terminal of the hose.

A bronze plug is furnished for closing the inlet when not in use.

The copper floats furnished for suspending the hose on the top of the water are
6/2 inches in diameter and are complete with clamp for attaching to the hose.

INSTRUCTIONS FOR INSTALLING AND USING TUEC No. 700 HAND MODEL CLEANER

Inlet connections should be approximately 8 inches below the water line and located
so that all parts can be reached with the shortest hose possible.

All pipe connections should be 2 inch female to receive 2 inch male thread of inlets.

The capacity of the pump to operate this satisfactorily should be 50 to 60 gallons per
minute. Either the filter pump or a portable pump can be used. (If a portable pump is
used an inlet should be installed on the intake of the pump and no inlets are required
on the inside of the pool.)

If the filter pump is used the discharge should not be returned to the filter.

A water strainer should be installed to keep heavy material out of the pump.

If it is necessary to place inlet connections above the water line, provisions should
be made for priming the pump so that the seal will not be broken if your pump is not
self-priming.

When the brush has become worn so that it is necessary to re-adjust, loosen the
two screws which hold the brush in place, set the brush to the proper position and
tighten the screws. The bristles should extend 1/16 inch below the wheels to insure
proper cleaning. With this adjustment the brush will give maximum service until the
bristles are entirely worn off. It can then be easily removed and returned to the factory
for re-bristling.

It is advisable to brush down the sides with a TUEC wall brush the night before
the pool is to be cleaned allowing the sediment to settle on the floor of the pool so that
it can be removed by the cleaner.

To put the cleaner in operation attach one end of the hose to the cleaning tool,
attach the handle;lower the cleaner to the floor-of the pool,-clamp the floats to the
hose as the hose is put into the pool, spacing them so the hose is suspended on the
top of the water, attach the other end of the hose to the inlet, start the pump and
move the cleaner back and forth over the floor of the pool. This is operated by one man
working from the sides of the pool.

SPECIFICATIONS FOR TUEC No. 700 HAND MODEL CLEANER

Vacuum Cleaner complete as manufactured by The Standard Pool Cleaner Com-
pany, Canton, Ohio, consisting of the following parts:

One 18 inch cleaning tool with adjustable brush,
three 1% inch diameter rubber wheels and swivel
castor. Nozzle opening and brush to be full length of
the nozzle with deflector extending 4 inches in front
of the nozzle.

Two 7'2 foot handles made of 1% inch diameter
brass tubing with bronze connections.

One 50 foot length 1’ inch diameter rubber lined
and rubbed covered reinforced hose with two bronze

tapered terminals.

One bronze inlet with smooth taper, male thread
for 2 inch pipe, 12 inch hub length.

One bronze plug tapered smooth to fit inlet.

Seven 6% inch diameter copper floats with clamps.

All castings throughout to be made of best quality
bronze, all connections used for attaching hose and
handles to be provided with bronze clamps.